1. Electrical Specification电气规格: Part 1 1.1 Table 1 Input Electrical Characteristics（输入特性） Input voltage range 输入电压 90Vac to 264Vac Normal voltage range标称输入 100Vac to 240Vac Frequency range 频率范围 50Hz/60Hz 5% Max input ac current 最大输入电流 4Amax at full load condition Inrush current (cold start) 浪涌电流 40Atyp peak, 120Vac;60Atyp peak, 220Vac AC-DC Efficiency (full load) 效率 90%min at 110/230Vac input 94%Mmax at 110/230Vac input DC-DC Efficiency (full load) 效率 98%MAX 36V 5%input 4*(32V 1V ) 1.25A 100mA Leakage Current 泄漏电流 Less Than 0.75mA, 240Vac input 额定功率 240W Input Fuse 输入保险 T6.3AH/250Vac 1.2 Output Electrical Characteristics（输出特性）1.2.1 Table 2 Output Voltage Current Regulation（输出电压电流调整率）Output Voltage输出电压Regulation调整率Min. current最小电流Rated current额定电流Peak current峰值电流+36V 5%0.0A6.6A7.0A Note:* The testing of peak current shall be performed under other dc output load rating and the peak current pulse width within 100ms conditions.峰值电流的测试条件是其它负载为额定负载，且脉宽小于100毫秒。 When is tested(power test only),testing shall be performed with rated load current of firstly, and then with load current of inverter. 在测试时（仅限Power测试），的额定负载电流，后带的负载电流。1.2.2 Table 3 DC Output Ripple Noise. （输出纹波和噪声）Output VoltageRipple Noise (Max.)+36V300mVp-p@25℃ Note: 1)Ripple Noise test: Ripple Noise bandwidth is set to 20MHz. 纹波和噪声测试：纹波和噪音带宽设置在20兆赫兹。 2)Use a 0.1uF ceramic capacitor in parallel with a 10uF electrolytic capacitor at output connector terminals for ripple noise measurements. 输出端并联一个0.1uF的陶瓷电容和一个10uF的电解电容来测试纹波和噪声。1.2.3 Output Transient Response. （输出动态响应） Table 4. Test condition.测试条件Voltage Tolerance LimitSlew RateLoad Change+36V/10%0.2A/uSMin. to 50% load and 50% to Max load Note: Load change repetition rate: 50Hz to 100Hz . 跳变负载频率:50~100Hz.1.2.4 Table 5 Hold-Up Time（输出保持时间）Output Voltage100Vac input220Vac input+36V 10 mS 10 mS Note: All of dc output at full load. 所有输出带满载。1.2.5 Table 6 DC Output Overshoot During Turn-On Turn-Off（输出超调）Output ChannelOutput(V)Overshoot voltage(V)超调电压Turn-on开机Turn-off关机+36V+36V 10% 10% Note: All of dc output current from Min. to Max. 测试时负载范围：最小到最大。1.2.6 Table 7 DC output voltage rise time（输出上升时间）Output Voltage120Vac input Full Load220Vac input Full Load+36V 30 mS 30mS Note: The rise time measured is when the output voltages rise from10% to 90% of specified output voltage Vout observed on the channel waveform. 上升时间为输出电压从10%上升到90%的时间。 1.3 Protection（保护功能）1.3.1 Table 8 DC Output Over current Protection（输出过流保护）Output VoltageOver CurrentComments+36V 7.1~9.5Atyp*Hiccup 保护后重起 Hiccup 保护后重起Note:The over current protection should be tested at other load rating. 过流保护测试是在其它额定负载时测试。1.3.2 Table 9 DC Output Short Circuit Protection（输出短路保护）Note: The Short Circuit protection should be tested at other load rating. 短路保护测试是在其它额定负载时测试。 2. Isolation（绝缘性能）2.1 Table 10 （绝缘阻抗）Output VoltageComments+36VHiccup保护后重起 Hiccup保护后重起 2.2 Table 11 （绝缘耐压）Note: Open FG and Output return. 交流地和输出负极要断开。 3. Safety （安全规格）The power supply shall comply with the following criterion:电源安全性满足下列标准:1) UL60950/UL600652) EN60950/EN600653) GB4943-1995/GB8898-2001 4. EMC （电磁兼容性）4.1 EMI （电磁干扰）The power supply shall comply with the following criterion:电源电磁干扰满足下列标准：1) Conduction Emission : （传导干扰度）*EN55013/EN55022, CLASS B*GB13837-2003, CLASS B*CISPR13:2001/FCC PART15 CLASS B2) Radiated Emission : （辐射干扰度）*EN55013/EN55022, CLASS B*GB13837-2003, CLASS B*CISPR13:2001/FCC PART15 CLASS B Note：The power board should be assembled in customer product to test for passing the above criterion.需配合用户电路整机通过上述标准。4.2 EMS （电磁抗扰）The power supply shall comply with the following criterion: 电源电磁抗扰满足下列标准：1) ESD （静电抗扰度）*GB17626.2-1998/IEC61000-4-2 Lever 32) EFT （脉冲群抗扰度） *GB17626.4-1998/IEC61000-4-4 Lever 33) SURGE （雷击浪涌） *GB17626.5-1998/IEC61000-4-5 Lever 3 4） DIP (电压跌落) *GB17626.11-1998/IEC61000-4-11 Class B/C 5. Environmental Requirement （工作环境）5.1 Temperature （环境温度）* Operating工作温度: -40℃ to +70℃. * Storage存储温度: -40℃ to +85℃.5.2 Humidity （环境湿度）* Operating工作: From 10%to90% relative humidity (non-condensing).* Storage存储: From 5 to 95% relative humidity (non-condensing).5.3 Altitude （海拔高度） * Operating: to10,000 ft.* Storage: to 20,000ft.5.4 Cooling Method （冷却方式） * Ventilation cooling . 风道自然冷却5.5 Vibration （振动耐受） * 10-55Hz, 19.6m/s (2G), 20minutes each along X, Y and Z axis.5.6 Shock（冲击耐受） * 49m/s (5G),11ms, once each X, Y and Z axis. 6. Dimension （物理尺寸） *186mm X 99mm X 39.5mm(长L *宽W * 高H ).