canneed “ABT-100喷雾罐耐压检测仪”适用于检测喷雾罐罐底耐压强度（凸罐强度）和爆破强度。将喷雾罐放入保护槽里充水加压来检测耐压强度。测量压力大约在2.2到2.8 Mpa。仪器操作使用简单。待检测罐须装满水，罐体可自动吸附在夹头上，夹紧后，缓慢加压，当压力超过罐的耐压极限时，罐底及罐盖部位发生变形向外凸出，由于体积突然增大，罐内压力突然减少，此时压力表指针会有短暂而且明显的停滞，显示值是喷雾罐耐压强度值（凸罐强度）。在此同时压力继续缓慢上升，罐破裂，压力表指针迅速回零，记忆指针显示的是喷雾罐爆破的最大值。一次装夹便可完成两个过程及读数。技术参数: 气源压力：0.5Mpa测试压力：0-4Mpa分度：0.2Mpa 尺寸：长x 宽x 高:555 x 400 x860 mm 重量：50kgThe “canneed ABT-100 Burst Buckling Tester for Aerosol Cans ” is used to determine the buckle value of bottom and end (dome) of aerosol cans and the pressure at which the can bursts. At high pressures from approximately 22 - 28 bar, it may happen that deformations of the valve and a higher burst pressure. Technical data (changes reserved):Pneumatic supply: 5bar Max. Working pressure: 40 bar Max. diameter: all standard aerosol cansDimensions: 555 x 400 x 860 mm(W x D x H)Weight: 50 kg